Table of Contents
Advertisement
Align the threaded studs sticking out of the top ladder section with the holes in the upper runway
9.
section. Attach the runway to the ladder using the hardware shown in FIGURE H. Tighten until
the lock washer is fully compressed. Notes: It may take more than one person to perform
this step. Verify that the gasket material is properly attached before assembling the parts.
FIGURE H
Stand the ladder upright and attach the runway entrance section to the runway exit section using
10.
the button head cap screws as shown in FIGURE I. Tighten the button head cap screws until the
lock washers are compressed. Notes: It may take more than one person to perform this
step.
Once the button head screws are tightened, insert the hex head cap screws into the underside of
11.
the runway as shown in FIGURE I. Tighten the hex head cap screws until the lock washers are
compressed.
(9)
(4)
(1)
First, fully assemble the water system components in the order shown in FIGURE J without gluing
12.
anything together. Assemble the water system parts to the ladder to ensure that everything fits
before proceeding. Be sure that the ball valve is properly centered in the recess of the ladder.
(1)
(4)
(4)
(2)
(4)
(2)
(1)
12
(2)
FIGURE I
(10)
(4)
Advertisement
Table of Contents
