Winmate M116P Series User Manual page 31

3. After selecting a desire scanning mode, click on the "Save to Device" on the side bar.
Scanning Mode Description
Manual Trigger When in manual trigger mode, the scanner scans until a bar code is read, or
until the trigger is released. Two modes are available, Normal and Enhanced.
Normal mode offers good scan speed and the longest working ranges (depth
of field). Enhanced mode will give you the highest possible scan speed but
slightly less range than Normal mode. Enhanced mode is best used when you
require a very fast speed and don't require a long working range. Default =
Manual Triger-Normal.
Presentation Presentation Mode uses ambient light and scan engine illumination to detect
Mode bar codes. When in Presentation Mode, the LEDs remain dim until a bar code
is presented to the scan engine, then the aimer turns on and the LEDs turn up
to read the code. If the light level in the room is not high enough, Presentation
Mode may not work properly.
When in Streaming Presentation mode, the scan engine's aimer goes out after
Streaming
Presentation
a short time, but the scan illumination remains on all the time to continuously
Mode search for bar codes. Two modes are available, Normal and Enhanced.
Normal mode offers good scan speed and the longest working ranges (depth
of field). Enhanced mode will give you the highest possible scan speed but
slightly less range than Normal mode. Enhanced mode is best used when you
require a very fast scan speed and don't require a long working range.
Host Notify Mode
Host Notify Mode bypasses the decoder and notifies the host that there has
been a hardware trigger pull. When in Host Notify Mode, it is up to the host to
initiate an Image Snap and/or an Image Ship command. It is also up to the
host to switch to another trigger mode.
Snap and Ship Snap and Ship mode, allows you to bypass the decoder and ship an image
Mode directly to the host. In this mode, an image is taken and shipped upon each
trigger pull, instead of being sent to the decoder. Snap and Ship is useful when
you are using your own decoder.
Chapter 4: Operating the Device
30