Remote Valet; Nuisance Prevention Circuitry - Directed Electronics Automate 417 Owner's Manual

To enter or exit Valet Mode:
1. Turn the ignition on.
2. Turn the ignition off.
3. Press and release the Valet
switch within 10 seconds.
The status LED will light steadily if you are entering Valet Mode and
will turn off if you are exiting Valet Mode.

Remote Valet

You can also activate Valet Mode with your transmitter:
1. Open any vehicle door.
2. Press the lock button on your transmitter.
3. Press the unlock button on your transmitter.
4. Press the lock button on your transmitter again.
The status LED will light solid if you are entering Valet Mode and
will turn off if you are exiting Valet Mode.
NOTE: The Remote Valet feature will not work with all factory keyless
entry systems, as some systems do not work when a vehicle door is open.
Nuisance Prevention
Your system has Nuisance Prevention Circuitry (NPC
prevents annoying repetitive trigger sequences due to faulty door
pin switches or conditions such as thunder, jackhammers, airport
noise, etc.
8
DRW-35
® Circuitry
® ). This circuitry
2000 Directed Electronics, Inc.
©