Table Of Zones; Programming Options - Directed Electronics Automate 417 Owner's Manual

Table of Zones

A zone is represented by the number of LED flashes used by the
system to identify a particular type of input. Standard input
assignments are listed in the following table, along with spaces to
write in any optional sensors or switches that have been installed.
ZONE
(Number of
DESCRIPTION
LED Flashes)
1
Instant trigger - often used
for hood/trunk pinswitches
2
Instant trigger - a heavier impact
detected by the on-board shock sensor
3
Door data bus trigger
4
Optional sensor
5
Ignition trigger
NOTE: The Warn Away response will not report on the LED.

Programming Options

Programming options control your system's normal, operational
setup. Most options do not require additional parts, but some may
require installation labor.
The system's programming options are listed here, with the
factory default settings in bold:
Active Arming (only with the remote) or Passive Arming (auto-
matic arming occurring 30 seconds after the last door is closed).
2000 Directed Electronics, Inc.
©
DEALER-INSTALLED
OPTIONS
11