Remote Valet; Nuisance Prevention Circuitry (Npc) - Directed Electronics 435 Owner's Manual

Hide thumbs Also See for 435:

Table of Contents

Remote Valet

You can also enter or exit Valet Mode using your remote transmitter:

1. Open any vehicle door.

2. Press

3. Press

4. Press

again.

The status LED will light solid if you are entering Valet Mode and

will turn off if you are exiting Valet Mode.

Nuisance Prevention

Your system has Nuisance Prevention

annoying repetitive trigger sequences caused by faulty door pin

switches or environmental conditions such as thunder, jackhammers,

airport noise, etc.

Here's how NPC

works: If the alarm is triggered by the same sen-

sor or switch three times within a 60-minute period, your system

interprets this pattern of triggers as false alarms. After the third

trigger, your system ignores, or bypasses, that sensor or switch (along

with any other sensors or switches sharing the same zone) for 60

minutes. If the bypassed sensor is triggered again while it is already

being bypassed, the 60-minute bypass period will start over.

This ensures that a sensor that is continually being triggered will

remain bypassed.

NOTE: Arming and disarming the system does not reset the Nuisance Pre-

vention Circuitry. The only ways to reset a bypassed zone are for that zone

not to be triggered for 60 minutes or to turn the ignition key on. When

1999 Directed Electronics, Inc.

Circuitry

Circuitry (NPC

) to prevent

Table of Contents