2. Install the
base
cover.
3. Follow the procedure in
Removing the M.2 2230 solid-state drive
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Disconnect the
battery
About this task
The figure indicates the location of the M.2 2230 solid-state drive and provides a visual representation of the removal
procedure.
Steps
1. Remove the screw (M2x4) that secures the solid-state drive to the palm-rest and keyboard assembly.
2. Slide and remove the solid-state drive module from the solid-state drive slot on the system board.
Installing the M.2 2230 solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the solid-state drive bracket and provides a visual representation of the bracket alignment
procedure to accommodate the M.2 2230 solid-state drive.
After working inside your
Before working inside your
cable.
computer.
computer.
Removing and installing components
25