Table of Contents
Advertisement
Steps
1. Slide the ports on the system board into the slots on the palm-rest and keyboard assembly and align the screw holes on the
system board with the screw holes on the palm-rest and keyboard assembly.
2. Replace the six screws (M2x4) that secure the system board to the palm-rest and keyboard assembly.
3. Connect the display cable on to the connector on the system board.
4. Adhere the tape that secures the display cable to the system board.
5. Replace the two screws (M2x5) that secure the USB Type-C port bracket to the system board.
6. Connect the keyboard cable to the system board and close the latch to secure the cable.
7. Replace the Mylar on the keyboard connector.
8. Connect the keyboard-backlight cable to the system board and close the latch to secure the cable.
9. Connect the touchpad cable to the system board and close the latch to secure the cable.
10. Connect the speaker cable to the system board.
11. Connect the power-adapter cable to the system board.
12. Connect the I/O-board cable to the system board and close the latch to secure the cable.
Next steps
1. Install the
display
assembly.
2. Install the
memory
module.
3. Install the
heat
sink.
4. Install the
left-side
fan.
5. Install the
right-side
fan.
6. Install the
WLAN
card.
7. Install the
M.2 2230 solid-state
8. Install the
M.2 2280 solid-state
9. Install the battery.
10. Install the
base
cover.
11. Follow the procedure in
drive.
drive.
After working inside your
computer.
Removing and installing components
59
Advertisement
Table of Contents
