Steps
1. Place the display assembly on a clean and flat surface.
2. Align and place the palm-rest and keyboard assembly on the display assembly.
3. Using the alignment posts, close the display hinges.
4. Replace the three screws (M2.5x5) that secure the left-display hinge to the system board.
5. Replace the three screws (M2.5x5) that secure the right-display hinge to the system board.
6. Connect the display cable on to the connector on the system board and adhere the tape to the system board.
Next steps
1. Install the
WLAN
card.
2. Install the battery.
3. Install the
base
cover.
4. Follow the procedure in
52
Removing and installing components
After working inside your
computer.