Steps
1. Align the notch on the solid-state drive module with the tab on the solid-state drive slot.
2. Slide the solid-state drive module firmly into the solid-state drive slot at an angle.
3. Replace the screw (M2x4) that secures the solid-state drive module to the system board.
Next steps
1. Connect the
battery
cable.
2. Install the
base
cover.
3. Follow the procedure in
Speakers
Removing the speakers
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the battery.
About this task
The figure indicates the location of the speakers and provides a visual representation of the removal procedure.
28
Removing and installing components
After working inside your
Before working inside your
computer.
computer.