Troubleshooting; Receiver Icon Troubleshooting - Danfoss R13 F User Manual

User Manual
R13 F Receiver

Troubleshooting

Receiver icon troubleshooting

Icon Description
Power failure
Hardware error
CAN error
Repose state due to active stop
Repose state due to passive stop
Linked state
Correct ID (link quality as indicated by the bar)
Incorrect ID
RF signal detected
Mask error
© Danfoss | January 2019
Action
Check the receiver power supply
Contact distributor; replace receiver
Contact your distributor
Release stop button and turn transmitter on
Reestablish link to activate the transmitter
Correct link
In case of no signal, check if the transmitter is turned on
In case of interference, change frequency channel
In case of interference, change frequency channel
Contact your distributor
BC292382016572en-000101 | 9