Cabinet Installation; Wot/Wotd-227 27" Double Wall Oven; Wot-127 27" Single Wall Oven - DCS WOT-127SS Installation Manual

CABINET INSTALLATION

Our Ovens are designed to be installed into a 27" and 30" minimum width cabinet. For the best appearance, to
conceal the raw edges and to ensure a snug and secure fit, the cutouts must be precise. Use the wall oven cutout
dimensions provided for your installation. Ovens are very heavy, we suggest two installers to lift ovens into the
cabinet opening.
■
Cut 2" x 4" runners or create a solid shelf to support the oven unit at the bottom.
■
The bottom support must be level and capable of supporting the weight of the oven unit –
(i.e 445 pounds – double oven or 275 pounds – single oven.)
■
The electrical cable should be a 3 conductor or 4 conductor wire as required by local codes
(must be hard wired and dedicated).
■
U. L. Listed conduit connector required.
■
The conduit box is to be located in the center below the oven, 2 inches below the bottom.
■
Power supply wiring should be connected prior to installing the oven to the cabinet.
2x4's or
similar
runners
or solid
structure
support
2x4's or
similar
runners
or solid
structure
support

WOT/WOTD-227 27" DOUBLE WALL OVEN

Cabinet Dimensions
27"
min.
Conduit
box centered
2" below bottom
of oven
2x4's or
similar supports

WOT-127 27" SINGLE WALL OVEN

Cabinet Dimensions
27"
min.
Conduit
box centered
2" below bottom
of oven
2x4's or
similar supports
Cut Out Dimensions
25-1/2 "
53-1/4 "
+1/16"
- 0"
(Suggested
distance from
floor 12" min.)
Floor
Cut Out Dimensions
25-1/2 "
(Suggested
distance from
floor 20" min.)
Floor
28-5/16 "
+1/16"
- 0"
5