Cabinet Installation; Wos/Wosd-227 27" Double Wall Ovens; Wos-127 27" Single Wall Ovens - DCS WOS-127 Installation Manual

CABINET INSTALLATION

CABINET INSTALLATION
Our Ovens are designed to be installed into a 27" and 30" minimum width cabinet. For the best
appearance, to conceal the raw edges and to ensure a snug and secure fit, the cutouts must be precise.
Use the wall oven cutout dimensions provided for your installation. Ovens are very heavy, we suggest
two installers to lift ovens into the cabinet opening.
Cut 2" x 4" runners or create a solid shelf to support the oven unit at the bottom.
The bottom support must be level and capable of supporting the weight of the oven unit –
(i.e 445 pounds – double oven or 275 pounds – single oven.)
The electrical cable should be a 3 conductor or 4 conductor wire as required by local codes
(must be hard wired and dedicated).
U. L. Listed conduit connector required.
The conduit box is to be located in the center below the oven, 2 inches below the bottom.
Power supply wiring should be connected prior to installing the oven to the cabinet.
WOS/WOSD-227 27" DOUBLE WALL OVEN
WALL OVEN
Cabinet Dimensions
27"
min.
2x4's or
similar
runners
or solid
structure
support
Cabinet Dimensions
27"
min.
2x4's or
similar
runners
or solid
structure
support
distance from
floor 12" min.)
Conduit
box centered
2" below bottom
of oven
2x4's or
similar supports
Floor
WOS-127 27" SINGLE WALL OVEN
Conduit
box centered
2" below bottom
of oven
2x4's or
similar supports
5
WALL OVEN
Cut Out Dimensions
25-1/2 "
53-1/4 "
+1/16"
- 0"
(Suggested
WALL OVEN
Cut Out Dimensions
25-1/2 "
(Suggested
28-5/16 "
distance from
+1/16"
floor 20" min.)
Floor
- 0"