Under Counter Installation; Wot-127 & 130 Single Wall Oven - DCS WOT-127SS Installation Manual

UNDER COUNTER INSTALLATION

WITH CTD-365 & CTD-304
WOT-127 & 130 SINGLE WALL OVENS
The WOT-127 and WOT-130 single ovens may be installed below the DCS CTD-365 or CTD-304 gas cooktop in a
standard 36" tall (to counter surface) base cabinet. Refer to diagram shown below for cabinet and countertop
cutout dimensions.
The gas shut-off valve and power supply receptacle for the cooktop must remain accessible from the front after
the units are installed. It is suggested that the valve and receptacle be located in the cabinet adjacent to the
wall oven on the right. To prevent interference with the wall oven chassis, the cooktop gas regulator must be
mounted at the shut-off valve. Use approved flexible gas tubing to make the connection between the regulator
and the cooktop.
Install the cooktop into the countertop first. Make the connections to the gas and power supplies as per the
cooktop installation instructions. Verify that the electrical service to the oven is shut off. Make the power
supply connections for the wall oven and then slide the unit into the cabinet.
CAUTION!
If the power leads are connected improperly, damage to the oven will result.
Secure unit to cabinet as noted in "Mounting the Wall Oven" section. Turn on all utilities and check both units
for proper operation.
WARNING!
When pushing wall oven into cabinet, be careful not to pinch the gas connection to the cooktop.
Cabinet Face
1-1/2"
Min.
28-5/16"
+ 1/16"
- 0"
4-3/4"
19-3/4"
25-1/2"
(27" Oven)
28-1/2"
(30" Oven)
34-3/4" for CTD-365
for CTD-304
28-5/8"
Electric Box
36"
7