Cabinet Installation; Wos-127 27" Single Wall Ovens - DCS WOS-227 Installation Manual

CABINET INSTALLATION
Our Ovens are designed to be installed into a 27" and 30" minimum width cabinet. For the best
appearance, to conceal the raw edges and to ensure a snug and secure fit, the cutouts must be precise.
Use the wall oven cutout dimensions provided for your installation. Ovens are very heavy, we suggest
two installers to lift ovens into the cabinet opening.
[] Cut 2"x 4" runners or create a solid shelf to support the oven unit at the bottom.
[] The bottom support must be level and capable of supporting the weight of the oven unit -
(i.e 445 pounds - double oven or 275 pounds - single oven.)
[] The electrical cable should be a 3 conductor or 4 conductor wire as required by local codes
(must be hard wired and dedicated).
[] U. L. Listed conduit connector required.
[] The conduit box is to be located in the center below the oven, 2 inches below the bottom.
[] Power supply wiring should be connected prior to installing the oven to the cabinet.
Cabinet Dimensions
Cut Out Dimensions
2x4's or
similar
runners
or solid
structure
support
(Suggested
distance from
floor 12" rain.)
Conduit
box centered
2" below bottom
of oven
2x4's or
_pports
Floor
2x4's or
similar
runners
or solid
structure
support
Cabinet Dimensions
Conduit
box centered
2" below bottom
of oven
2x4's or
-- similar supports
(Suggested
distance from
floor 20" min.)
+
Floor
f
Cut Out Dimensions