Service And Maintenance - Infortrend EonStor GSe Pro 1000 Series Hardware Manual

 If the system is not going to be used for a long period of time,
disconnect it from the power mains to avoid transient over-voltage.
 For power source redundancy, please make sure that the two PSUs are
plugged into two different power sources (i.e. Different circuit breakers).

Service and Maintenance

 Keep the faulty module in place until you have a replacement unit; an
empty module greatly affects the airflow efficiency within the enclosure.
 During service operation, place the enclosure on soft and clean surface
to prevent exterior damage. Do not place tools or other items on top.
 When transporting the enclosure, repackage all disk drives separately in
the original package foam blocks. Replaceable modules can stay in the
enclosure if you are using the original package; if not, repackage them
separately as well.
 Disconnect the power cords before servicing or cleaning the enclosure.
 Use a slightly moistened paper sheet or cloth for cleaning. Avoid using
liquid or sprayed detergent.
 When replacing components, insert them as gently as possible while
assuring full engagement. Vibration and shock can easily damage hard
drives.
 Only qualified service personnel should open the enclosure.
 Contact service personnel if any of the following situations occurs:
- The power cord or plug is damaged.
- The enclosure has been exposed to moisture.
- The system has not been working properly.
- The enclosure was dropped against a hard surface.
- The enclosure shows obvious signs of breakage.
 To move the enclosure, it is recommended to remove the drives from
the enclosure beforehand.
Safety Precautions
6