Safety Precautions; Energy Hazards Precaution; Installation And Operation - Infortrend EonStor GSe Pro 1000 Series Hardware Manual

Safety Precautions

Read these instructions carefully before you install, operate, or transport the system
and expansion enclosures.

Energy Hazards Precaution

This equipment is intended to be used in Restrict Access Location, like computer
room. The access can only be gained by SERVICE PERSONS or by USERS who
have been instructed about the metal chassis of the equipment is have energy
hazards that service persons have to pay special attention or take special protection
before touching it. Further, the access is through the use of key or security identity
system. Only authorized by well trained professional person can access the restrict
access location.

Installation and Operation

 Install the rack cabinet and the associated equipment at a site where
the ambient temperature (special room cooling equipment may be
required) stays lower than 40C.
 Install the power source socket outlet near the enclosure where it is
easily accessible and ground the rack cabinet.
 Secure airflow clearance inside and around the rack cabinet.
- Secure an 18 to 20cm clearance on the rear side.
- Do not cover the enclosure openings.
- Route the cables inside the rack cabinet.
- Do not leave drive bays empty as it will affect airflow efficiency.
 Secure each enclosure module using its retaining screws.
 Place power cords and other cables away from foot traffic. Do not place
items on top of power cords and make sure they do not rest against
data cables.
 Install all modules to the enclosure before powering-on systems.
 Ensure that the correct power range is being used before powering-on.
 DO NOT remove covers or replaceable modules if they are not faulty.
Safety Precautions