Proxim AP-4000MR-LR Quick Install Manual page 21

Note:
If.your.Access.Point.does.not.appear.in.the.Scan.List,.click.the.Rescan.
button.to.update.the.display..If.the.unit.still.does.not.appear.in.the.list,.see.
the.Troubleshooting.chapter.in.the.AP-4000MR-LR User Guide.for.suggestions..
Note that after rebooting an Access Point, it may take up to five minutes for
the.unit.to.appear.in.the.Scan.List.
3. Do.one.of.the.following:
▪ If.the.AP.has.been.assigned.an.IP.address.by.a.DHCP.server.on.the.
network,.write.down.the.IP.address.and.click.Cancel.to.close.ScanTool..
Proceed.to.the.Logging In.section.below.for.information.on.how.to.access.
the.HTTP.interface.using.this.IP.address.
Note:
Mesh APs must be configured with static IP addresses. To assign the AP a
static.IP.address,.follow.the.steps.below.
▪ If.the.AP.has.not.been.assigned.an.IP.address.(in.other.words,.the.unit.
is.using.its.default.IP.address,.169.254.128.132),.follow.these.steps.to.
assign.it.a.static.IP.address.that.is.valid.on.your.network:
a. Highlight the entry for the AP you want to configure.
b. Click.the.Change.button..The.Change.screen.appears.
c. Set.IP.Address.Type.to.Static.
All rights reserved Page 21