Step.2:.Pre-Assemble.the.hardware - Proxim AP-4000MR-LR Quick Install Manual

step 2: Pre-Assemble the hardware
1. Unpack.the.unit.and.accessories.from.the.shipping.box.
2. Note.the.Ethernet.and.MAC.addresses.of.the.unit,.as.well.as.the.serial.
number; these addresses may be used when configuring the unit.
Note:
The.serial.number.is.required.to.obtain.support.from.Proxim...Keep.this.
information.in.a.safe.place.
3. You.will.be.attaching.an.outdoor-rated.24.AWG.CAT5.cable..(diameter..114.
to..250.inches/2.9.to.6.4.mm).(not.provided).to.the.Power-over-Ethernet.
port.on.the.back.of.the.unit.later.in.the.installation.procedure...First,.you.
must construct the cable and assemble the waterproofing cable covers as
described.in.the.following.steps:
.i.. Slide.the.sealing.nut.(A).over.the.bare.end.of.the.CAT5.cable.
.ii.. Slide.the.lock.nut.(B).over.the.bare.end.of.the.CAT5.cable.
.iii.. Slide.the.RJ45.sealing.cap.(C).over.the.bare.end.of.the.CAT5.cable..
.iv.. Terminate.the.RJ45.connector.to.the.CAT5.cable..Insert.into.the.
mating.RJ45.connector.(D).
.v.. Slide.the.RJ45.sealing.cap.(C).over.the.RJ45.connector.and.thread.
onto.enclosure..Hand.tighten.
.vi.. Thread.the.lock.nut.(B).onto.sealing.cap.(C),.and.hand.tighten.
.vii..Thread.the.sealing.nut.(A).onto.the.lock.nut.(B),.and.hand.tighten.
Caution!.
Hand-tighten only. Torque values for final installation are provided
in.Step 7: Complete Installation.
Page 10 Copyright © 2006 Proxim Wireless