Noise Or Vibration Coming From Motor; Motor Will Not Run At Variable Speeds; Difficulty Deploying Or Stowing; Foot Control Unit Not Operational - Watersnake Shadow MK II SWNG 44/48 Owner's Manual

SHADOW MK II

Noise or vibration coming from motor

Check that propeller is securely tightened and shear pin is in place
Remove propeller and check for any build up of fi shing line / weed or any
other debris
• Check that your 12v deep cycle marine battery is fully charged (+ 12v)

Motor will not run at variable speeds

• Check that your 12v deep cycle battery is fully charged (+ 12v)
• Check terminals / connections are secure and not loose
• Check terminals / connections / fuse or circuit breaker for any signs of
damage, corrosion or build up of debris
• Check that foot control plugs are not not loose
• Check that foot control constant on/off switch is in the on position
(refer page 13)
Diffi culty deploying or stowing
• Ensure that you are following the correct deployment / stowing process
(refer diagram on page 5)
• Check for any obstructions within the mounting bracket
• Lubricate shaft with spray lubricant
(concentrate spray on area where shaft runs through turning motor housing)
• Clean any debris from the mounting bracket
• Remove the side plastic covers from the mounting bracket and apply marine
grade grease to the mechanism
Remote control hand unit not operational
• Battery may need to be changed
• Re-sync hand unit to motor (refer page 12)
Foot control unit not operational or one or more functions not operational
• Check that foot control lead plugs are secured
• Refer to foot control operation guide on page 13
A number of service videos are available on the Jarvis Walker Brands
Youtube channel – search "Jarvis Walker Brands" from the Youtube search
function. Please contact Jarvis Walker or your nearest service agent should
issues persist.
www.watersnake.com.au
17