Deep Cycle Batteries; Deployment; Depth Adjustment - Watersnake Shadow MK II SWNG 44/48 Owner's Manual

WIRE EXTENSION LENGTH
Note that above table is intended as a guide only. Your local electrical supplier will
be able to advise in greater detail based on your particular set up and requirements.

DEEP CYCLE BATTERIES

A 12 v deep cycle marine battery is required for normal operation and
continued use of your Watersnake motor. 12 v deep cycle marine batteries are
constructed using thicker plates and a denser active material. They are built to
withstand repeated charge and recharge cycles. Deep cycle marine batteries
are specifi cally designed to deliver sustained power with low current draw over
extended periods of time. Car / Truck / Motorcyle batteries are not designed
in the same way and are more useful for providing high bursts of power for
short periods. Use of car / truck / motorcycle batteries can cause damage to
electronic components within your Watersnake motor.

DEPLOYMENT

Pressing on the quick locking and release lever (refer to diagram on page 4)
at the same time as pushing the shaft forward will allow the motor to release
from the cradle. NOTE – Your Watersnake motor is not designed to release
from the cradle by pressing on the lever alone. Applying excessive pressure to
the release lever can lead to deployment diffi culties.

DEPTH ADJUSTMENT

Hold the motor shaft with one hand, loosen the depth collar adjustment screw
and set the motor to the desired depth. Then retighten the adjusting screw on
the depth collar securely.
10
1m
3m
5m
SUGGESTED WIRE GAUGE
6 AWG / 6GA
4 AWG / 4GA
2 AWG / 2GA
Watersnake