Syncing The Remote Control To The Motor - Watersnake Shadow MK II SWNG 44/48 Owner's Manual

Your remote control should already be synced to your motor.
In the event that it is not please follow the below instructions.

SYNCING THE REMOTE CONTROL TO THE MOTOR

Please make sure before syncing the motor is conected to Power
1. Uscrew the two screws and remove the side
plate of bow mount bracket.
(Opposite side to the wire assembly )
2. locate the remote control receiver board.
3. Press any button on the remote control at the
same time you press the button on the
remote control receiver board. Hold until
you see the LED flash.
4. Check to see if remote is now working.
If not repeat step 3 again.
5. Put side plate back on bow mount bracket
and secure with the two screws.
LED
12
Receiver
Button
Remote Control
Receiver Board
Watersnake
Side Plate Bracket
Screw
Remote
Control
Screw