BATTERY AND POWER
CONNECTING YOUR MOTOR TO THE BATTERY
All Watersnake wiring connections should conform to best marine standards.
Soldered, sealed and heat-shrink protected. If you doubt your ability to
produce quality waterproof connections or lack the equipment, consult a
marine technician or auto electrician.
• Your Watersnake comes factory-fi tted with a standard length of twin fl ex
wiring with ring terminals to attach to the battery.
• Before connecting the motor's cables to the battery terminals, ensure all
switches are in the OFF position and stand clear of the propeller.
• Connect the red cable to the positive (+) terminal and the black cable to the
negative (-) terminal, making sure the terminals are clean before doing so. A
clean connection will minimise power wastage and give you maximum
power from the battery.
• When not in use please make sure that the motor is disconnected from the
battery.
USING THE MOTOR
PRE-USE CHECKLIST – CHECK BEFORE EACH USE
• Ensure that your Watersnake motor is securely attached to your boat
(refer to page 7 of manual)
• Fully charged 12v deep cycle or LiFePO4 battery
(your Watersnake motor is not designed to be used with a car / truck /
motorcycle or marine cranking battery)
• Check battery cable for any signs of damage or exposed wiring
• Check terminals for any signs of corrosion or debris
• Check Anderson plugs are clean and corrosive free
PLEASE NOTE: Please ensure this Watersnake motor is not your only
means of propulsion. Please follow the marine safety guidelines set by
your state or country of use.
www.watersnake.com.au
19