Table of Contents
Advertisement
CAUTION: This product must be earthed.
Check you have all of the items included in the checklist on Page 7
Note the mounting position advice and warnings offered in Section 4.1.1 Considerations on
page 10
Flush-fitting the wall box (chased-in cables):
Remove the 4 cover screws from the wall mounting box with the hex wrench provided
Feed the mains supply via the cable entry hole on the back plate
Connect the mains supply to the fused terminal block found on the back plate
Using the back-plate as a template, mark its position on the wall, bearing in mind
the final position of the light-head. Fixing point dimensions on page 16 of this manual
Fix the bracket to the wall
Fit the power supply module to the wall bracket with the 4 cover screws
Switch the power on and check for correct operation
Nut
Non-slip washer
Terminal block
Page 17 of 27
Advertisement
Table of Contents
