Mpcie / Msata Selection For Mpcie1 (Jp3); Mpcie / Msata Selection For Mpcie2 (Jp4); Table 48: Pin Assignment Jp2; Table 49: Pin Assignment Jp3 - Kontron mITX-SSH-S User Manual

Table 48: Pin Assignment JP2

Jumper 1 Position
Description
Pin 1-2 Pin 2-3
X - Normal (default position)
- X Clear RTC CMOS (board does not boot with the jumper in this position)
"X" = Jumper set (short) and "-" = jumper not set (open)
Do not leave the jumper in position 2-3, otherwise if the power is disconnected, the
battery will fully deplete within a few weeks.

7.20.3. mPCIE / mSATA Selection for MPCIE1 (JP3)

Figure 36: mPCIE / mSATA Selection JP3

Table 49: Pin Assignment JP3

Jumper 1 Position
Description
Pin 1-2 Pin 2-3
X - mSATA
- X mPCIE
"X" = Jumper set (short) and "-" = jumper not set (open)

7.20.4. mPCIE / mSATA Selection for MPCIE2 (JP4)

Figure 37: mPCIE / mSATA Selection JP4

Table 50: Pin Assignment JP4

Jumper 1 Position
Description
Pin 1-2 Pin 2-3
www.kontron.com
1
2
3
1
2
3
1
2
3
mITX-SSH-S - User Guide, Rev. 1.0
// 63