Accessing The Telnet Interface - D-Link DP-G310 User Manual

protocol) table to add a mapping from the IP address you
want to assign to the print server's Ethernet address. For
many TCP/IP systems, this is done with a command of the
form:
arp -s ip-address ethernet-address
For example, to assign the address
server with MAC address
command:
arp -s 202.39.74.40 0080C8142634
Note: on a U
( ) permission to execute the
root
3. From the host with the modified ARP table, send an ICMP
echo request to the print server using the
ping 202.39.74.40
When the print server receives an ICMP request at its own
Ethernet address, but with a different IP address than the one it
was expecting, it changes its IP address setting.
4. The print server will now respond to the new IP address. At
this point you can use the
below) to change the host's other settings.

Accessing the Telnet Interface

You can access your print server's
ordinary
telnet
to invoke a
telnet ip-address
Appendix: Telnet Interface Administration
00 80 C8 14 26 34
-based system, you will need to have superuser
NIX
telnet
client program. On many systems, the command
client is:
telnet
Print Server Administration User's Guide
to the print
202.39.74.40
, use the
command.
arp
command:
ping
interface (as described
interface using an
telnet
83