D-Link DP-G310 User Manual page 34

Print Server Administration User's Guide
Description See above.
Baud Rate Sets the serial communications bit rate, in
bits per second. Most printers default to 9600bps; rates
from 300bps to 115200bps are available.
Data Bits Sets the number of bits transmitted per byte on
the serial port. Most modern printers use 8-bit data.
Stop Bits Sets the number of stop bits transmitted per
byte on the serial port. Most modern printers use serial
protocol with 1 stop bit.
Parity Bits Sets the type of parity check bit sent with
each byte on the serial port. Most modern printers use a
non-parity serial protocol.
XON/XOFF Flow Control Determines whether or not
the print server should respond to software flow control
requests from the printer. When software flow control is
used, the printer will send an XOFF character (Control-S)
to the print server when its buffer is getting full, and an
XON character (XON) when the buffer is no longer full.
Hardware Flow Control Determines whether or not the
print server should respond to hardware flow control
requests from the printer. When hardware flow control is
used, the printer will use the DTR, RTS, or both RS-232
control lines to control the print server's transmission of
data in order to prevent the printer's buffers from getting
full.
4. Click OK to exit the Port Configuration dialog.
5. Click OK to exit the Server Device Configuration dialog
window.
28
Getting Started Setting up Your Print Server