Snmp Information - D-Link DFE-2600 Series User Manual

Dual-Speed Stackable Hubs User's Guide
Boot Server IP Address. This variable is the IP address of the
TFTP server where the configuration file is located. This entry is
used only if the S/W Update Control is enabled and your boot proto-
col is TFTP only; if you are using BOOTP&TFTP mode, or if Send
BOOTP Request on Power Up is enabled, the address will be ob-
tained from the BOOTP server.
Boot File Name. The pathname of the configuration file on your
TFTP server. If you are using D-View as your TFTP server, this is
the pathname of the .CFG file on your hard disk. This entry is used
only if your boot protocol is TFTP ONLY; if you are using
BOOTP&TFTP mode, or if Use BOOTP to get IP after start up is
enabled, the pathname will be obtained from the BOOTP server. For
more information about the DFE-2600 series master hub configura-
tion file, see Appendix C, Boot Configuration File.
DFE-2600 Stackable Hub - Software Update Menu
Software Update
Software Update Mode
Boot Protocol
Boot Server IP Address
Boot File Name
Last Boot Server IP Address:

SNMP Information

The System Configuration Menu screen shows a variety of information
about your hub, and allows you to set the System Name, System Location,
50
<Disable>
<Network >
<TFTP ONLY >
[210.68.85.36 ]
[c:\dfe2600i.cfg
210.68.85.35
HELP SAVE
Master Hub Setup and Management
]
EXIT