D-Link DFE-2600 Series User Manual page 47

Ethernet/fast ethernet dual-speed managed/unmanaged stackable hubs

Hide thumbs Also See for DFE-2600 Series:

Table of Contents

Collision—This LED blinks when there are packet collisions on the

module line.

FDX—This LED is lit when the port is set for Full Duplex transmit and

receive. When the LED is off, the port is in Half Duplex mode.

NOTE:

Because the DFE-260TX module's port is an

NWay UTP port, once the hub is powered on,

it will automatically detect the duplex and

speed modes of any device connected to it.

The DIP switch may then be set to force the

duplex mode into a particular state. After the

DIP switch is set, the DFE-260TX will only op-

erate at 100Mbps in the duplex mode

selected.

The duplex mode DIP switch allows you to set the port to Full Duplex

mode operation. Only the right-hand switch (number 2) is active. Use the

DIP switch to set the duplex mode.

Making Connections

Table of Contents