D-Link DFE-2600 Series User Manual page 59

Subnet Mask. This parameter sets the subnet mask that determines
the level of the subnet that the hub is on. Should be of the form
xxx.xxx.xxx.xxx, where each xxx is a number (represented in deci-
mal) between 0 and 255. If no subnetting is being done, the value
should be 255.0.0.0 for a Class A network, 255.255.0.0 for a Class B
network, and 255.255.255.0 for a Class C network.
Default Gateway. This parameter specifies the IP address for a
gateway or a router where frames with destinations outside the cur-
rent subnet should be sent.
internetwork, or you do not want the hub to be accessible outside
your local network, you can leave this field blank.
Send BOOTP Request Upon Power Up. This parameter deter-
mines whether or not the hub should send out a BOOTP request
when it is powered up. The BOOTP protocol allows IP addresses,
network masks, and default gateways to be assigned from a central
BOOTP server; if this option is set to " yes," the hub will first look
for a BOOTP server to provide it with this information before using
local settings.
DFE-2600 Stackable Hub - TCP/IP Parameters Configuration Menu
Master Hub Setup and Management
If your network is not part of an
Interface #<1 Media Type: Ethernet>
Current Setting
IP Address: 210.68.85.51
Subnet Mask: 255.255.255.0
Default Gateway: 210.68.85.126
System Restart Setting
IP Address [210.68.85.51
Subnet Mask [255.255.255.0
Default Gateway [210.68.85.126
Send BootP Request Upon Power Up <No >
]
]
]
HELP SAVE EXIT
47