Out-Of-Band Management And Console Settings; Out - D-Link DFE-2600 Series User Manual

Dual-Speed Stackable Hubs User's Guide
The default setting for all TCP/IP variables is 0.0.0.0.
Out-of-Band Management and Console
Settings
You can use the Out-of-Band/Console Setting menu to choose whether to
use the hub's RS-232 serial port for console management or for out-of-band
TCP/IP communication using SLIP, and to set the baud rate used for SLIP
communications.
The following fields can be set:
System Restart Out-of-Band Baud Rate. This parameter deter-
mines the serial port baud rate that will be used the next time the hub
is restarted. It applies only when the serial port is being used for
out-of-band (SLIP) management; it does not apply when the port is
used as a console port. Available speeds are 1200, 2400, 9600, and
19200 bits per second.
Out-of-Band Dial Up Phone Number. This information is stored
as a reference for the benefit of the system manager and does not
cause the hub to dial out.
System Restart Serial Port Setting. This parameter determines
whether the serial port should be used for out-of-band (SLIP) man-
agement or for console management, starting from the next time the
hub is restarted. It can be set to either " Console" or " Out-of-
Band."
48 Master Hub Setup and Management