tings (including TCP/IP parameters, SNMP parameters, the en-
abled/disabled settings of ports, etc.) will be erased and restored to their
factory default settings.
1.
Choose Factory Reset NVRAM to Default Value from the main
menu. A confirmation message similar to that for the System Reset
will appear.
2.
Move the cursor to Yes to confirm the reset and press <Enter>.
After a few seconds delay, the hub should restart, and all of its pa-
rameters will revert to their default values.
Note:
Doing a factory reset to the Primary Master
also resets the Backup Master variables ex-
cept for the the Backup Master IP address.
Master Hub Setup and Management
71