Perkins 1204F-E44TA Operation And Maintenance Manual page 65

SEBU9063-07
(Table 12, contd)
Factory Installed Aftertreatment #1 Identification Number
DPF #1 Soot Loading Sensing System Configuration Code
Limp Home Engine Speed Ramp Rate
System Operating Voltage Configuration
Rating Number
CAN Communication Protocol Write Security
Engine Emissions Operator Inducement Progress Configuration
Engine Emissions Operator Inducement Regulation Configuration
Engine Emissions Operator Inducement Emergency Override Enable
Status
Engine Emissions Operator Inducement Emergency Override
Activation
Engine Emissions Operator Inducement Emergency Override Mode
Configuration
Engine Emissions Operator Final Inducement Action
Customer Specified Parameters
Customer specified parameters allow the engine to
be configured to the exact needs of the application.
The electronic service tool is required in order to alter
the customer configuration parameters.
Customer parameters may be changed repeatedly as
operational requirements change.
Table 13
Specified Parameters
Throttle Type Channel 1
Throttle Type Channel 2
IVS Channel 1
IVS Channel 2
Continuous Position Throttle Configuration 1
Continuous Position Throttle Configuration 2
Multi Position Throttle Switch Configuration
Throttle Arbitration
Equipment ID
Low Idle Speed
Ether Solenoid Configuration
Engine Warm Up Elevated Idle Feature Enable Status
Engine Warm Up Elevated Idle Delay Time
Customer Specified Parameters
Record
65
Operation Section
Configuration Parameters
(continued)