Perkins 1204F-E44TA Operation And Maintenance Manual page 37

SEBU9063-07
Some applications may require a frame or jig to lift
the CEM. A frame or jig must only be connected to
the cradle of the CEM. Refer to the Original
equipment manufacture for more information.
DOC, DPF, and SCR
Illustration 32
Typical example
The approximate weight of the CEM is 77 kg
(170 lb).
Two suitable double looped slings are required to lift
the CEM. Also, a suitable hoist will be required to
remove and install the assembly.
The slings must be attached to the CEM as shown in
illustration 32 .
Some applications may require a frame or jig to lift
the CEM. A frame or jig must only be connected to
the cradle of the CEM. Refer to the original
equipment manufacture for more information.
Product Lifting
NOTICE
Always inspect lifting eyebolts and all other lifting
equipment for damage before performing any lifting.
Never bend the eyebolts and the brackets. Never
perform product lifting if components are damaged.
Only load the eyebolts and the brackets under ten-
sion. Remember that the capacity of an eyebolt is
less as the angle between the supporting members
and the object becomes less than 90 degrees.
When it is necessary to remove a component at an
angle, only use a link bracket that is properly rated for
the weight.
37
Operation Section
Product Lifting
g03713453
i07434759