Coolant (Deac) - Change - Perkins 1204F-E44TA Operation And Maintenance Manual

SEBU9063-07
Clean Emissions Module Support
- Inspect
Illustration 56
Typical example
There are three mounts on the Clean Emissions
Modules (CEM) that must be inspected.
1. Inspect mount (1) for wear or damage.
2. Inspect mounts (2) for wear or damage, if wear or
damage is found the mounts must be replaced.
3. Refer to the Disassembly and Assembly, "Support
and Mounting (CEM) - Remove and Install" for
more information.
If the Clean Emissions Module is remote-mounted,
the mounts must also be inspected for wear or
damage.

Coolant (DEAC) - Change

• DEAC Diesel Engine Antifreeze Coolant
Clean the cooling system and flush the cooling
system before the recommended maintenance
interval if the following conditions exist:
• The engine overheats frequently.
• Foaming is observed.
i07711014
• The oil has entered the cooling system and the
coolant is contaminated.
• The fuel has entered the cooling system and the
coolant is contaminated.
When any servicing or repair of the engine cooling
system is performed, the procedure must be per-
formed with the engine on level ground. Level ground
will allow you to check accurately the coolant level.
This procedure will also help in avoiding the risk of in-
troducing an air lock into the coolant system.
Note: Inspect the water pump and the water
i05676795
temperature regulator after the cooling system has
been drained. This inspection is a good opportunity
to replace the water pump, the water temperature
regulator, and the hoses, if necessary.
Maintenance Section
Clean Emissions Module Support - Inspect
NOTICE
107
g03723522