Engine Oil Level - Check; Engine Mounts - Ins Pect - Perkins 1204F-E44TA Operation And Maintenance Manual

SEBU9063-07
Check the System
Illustration 71
(1) Connection to breather cap for the engine
(2) Oil drain
(3) Tube assembly to atmosphere
(4) Outlet
Check the system for damage. Replace any
component that is damaged. Ensure that the outlet
(4) is clear and free from obstructions.
Engine Mounts - Inspect
Note: The engine mounts may not have been
supplied by Perkins. Refer to the Original Equipment
Manufacturer (OEM) information for further details on
the engine mounts and the correct bolt torque.
Inspect the engine mounts for deterioration and for
correct bolt torque. Excessive engine vibration can
be caused by the following conditions:
• Incorrect mounting of the engine
• Deterioration of the engine mounts
• Loose engine mounts
Any engine mount that shows deterioration should be
replaced. Refer to the OEM information for the
recommended torques.
When the engine mounts are supplied by Perkins the
maintenance procedure will be supplied in the
Disassembly and Assembly manual for your engine.

Engine Oil Level - Check

Hot oil and hot components can cause personal
injury. Do not allow hot oil or hot components to
contact the skin.
g02416001
Illustration 72
"L" Low
"H" High
i07819538
Perform this maintenance with the engine stopped.
Note: Ensure that the engine is either level or that
the engine is in the normal operating position in order
to obtain a true level indication.
Note: After the engine has been switched OFF, wait
for 10 minutes in order to allow the engine oil to drain
to the oil pan before checking the oil level.
1. Maintain the oil level between the mark (L) and the
mark (H) on the engine oil dipstick. Do not fill the
crankcase above the "H" .
Maintenance Section
Engine Mounts - Inspect
i05300117
g02173847
NOTICE
119