Troubleshooting - Axxess AX-GMCL2-SWC Installation Instructions Manual

STEERING WHEEL CONTROL SETTINGS
Dual assignment legend
1. Not allowed 4. Seek-Down/
Prev
2. Not allowed
5. Mode/Source
3. Seek-Up/Next
6. ATT/Mute
* Not applicable in this application
Resetting the AX-GMCL2-SWC
1. The Blue reset button is located inside the interface, between the two connectors. The button is accessible outside the
interface, no need to open the interface.
2. Press and hold the reset button for two seconds, and then let go to reset the interface.
3. Refer to "Programming the Interface" from this point.
AxxessInterfaces.com
7. Preset-Up 10. Band
8. Preset-Down 11. Play/Enter
9. Power 12. PTT

TROUBLESHOOTING

© COPYRIGHT 2018 METRA ELECTRONICS CORPORATION
(CONT)
13. On-Hook 16. Fan-Down *
14. Off-Hook 17. Temp-Up *
15. Fan-Up * 18. Temp-Down *
AX-GMCL2-SWC
I N S TA L L AT I O N I N S T R U C T I O N S
IMPORTANT
If you are having difficulties with the installation of this product,
please call our Tech Support line at 1-800-253-TECH. Before doing
so, look over the instructions a second time, and make sure the
installation was performed exactly as the instructions are stated.
Please have the vehicle apart and ready to perform troubleshooting
steps before calling.
K
®
NOWLEDGE IS
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
P
OWER
REV. 7/24/18 INSTAX-GMCL2-SWC