Danfoss VLT AQUA Drive FC 202 Operating Manual page 35

Electrical Installation
Terminal description
Default
Terminal Parameter setting
Digital inputs/outputs
12, 13 +24 V DC
–
Parameter 5-
10 Terminal
18 Digital
18 Input [8] Start
19 Parameter 5-
11 Terminal
19 Digital
Input [10] Reversing
32 Parameter 5-
14 Terminal
32 Digital [0] No
Input operation
33 Parameter 5-
15 Terminal
33 Digital [0] No
Input operation
27 Parameter 5-
12 Terminal
27 Digital [2] Coast
Input inverse
29 Parameter 5- [14] Jog
13 Terminal
29 Digital
Input
20
–
37 – STO
Table 4.1 Terminal Description Digital Inputs/Outputs
MG21A402
Operating Guide
Description
24 V DC supply
voltage for digital
inputs and external
transducers. Maximum
output current
200 mA for all 24 V
loads.
Digital inputs.
For digital input or
output. Default setting
is input.
Common for digital
inputs and 0 V
–
potential for 24 V
supply.
Safe input.
Danfoss A/S © 11/2016 All rights reserved.
Terminal description
Default
Terminal Parameter setting
Analog inputs/outputs
39
– –
42 Parameter 6- [0] No
50 Terminal operation
42 Output
50 +10 V DC
–
Parameter
group 6-1*
Analog
53 Input 53 Reference
54 Parameter Feedback
group 6-2*
Analog
Input 54
55
– –
Table 4.2 Terminal Description Analog Inputs/Outputs
Terminal description
Default
Terminal Parameter setting
Serial communication
61
–
Parameter
group 8-3*
FC Port
68 (+) Settings
69 (-) Parameter
group 8-3*
FC Port
Settings
Table 4.3 Terminal Description Serial Communication
Description
Common for analog
output.
Programmable analog
output. 0–20 mA or
4
4–20 mA at a
maximum of 500 Ω.
10 V DC analog
supply voltage for
potentiometer or
thermistor. 15 mA
maximum.
Analog input. For
voltage or current.
Switches A53 and A54
select mA or V.
Common for analog
input.
Description
Integrated RC-filter for
cable shield. ONLY for
connecting the shield
if EMC problems
occur.
RS485 interface. A
control card switch is
provided for
termination resistance.
33
4