D-Link DES-6300 User Manual page 21

The All-default command displays all fields with their default values on the screen.
To use the All-default command:
•
After the values are set, the number of affected fields is displayed.
Command—Clear (c)
The clear command clears all the working variable field values displayed on the
screen.
To use the Clear command:
•
Command—Default (f)
The Default command changes a field displayed on the screen to its default value.
To use the Default command:
1. Enter the command f at the command prompt and press <Enter>.
2. On the prompt select the field to set as the default value.
3. Press <Enter>.
The field is displayed on the screen with the default value. If the field does not have a
default value, an error message is displayed.
Command—Delete (d)
The Delete command deletes a variable entry. A scalar variable cannot be deleted.
Delete is an SNMP command.
To use the Delete command:
1. Enter all key-fields and press <Enter>.
2. Enter the command d at the command prompt and press <Enter>. A confirmation
3. Press Y. The entry is deleted from the MIB database.
Command—Edit (e)
The Edit command modifies variable fields in the working variable. The Edit
command modifies the MIB database.
To use the Edit command:
1.
2.
Enter the command i at the command prompt and press <Enter>.
Enter the command c at the command prompt and press <Enter>.
prompt appears.
Enter all key-fields and press <Enter>.
Edit the fields using one of the following methods:
• Accept the default values
• Selecting the field and entering the value
• Use the Get or Get-Next command (see below)
• Use the Clear command (see above)
Screen Mode
4-5