Chapter 4 Screen Mode - D-Link DES-6300 User Manual

Chapter 4 Screen Mode

Screen mode is dedicated to one specific MIB variable at a time. The active MIB
variable is called the "working variable." There are two types of MIB variables:
•
•
Commands within Screen mode are SNMP based commands. Any SNMP command
syntax errors are displayed by an error message.
Note: To modify a MIB variable that is field in a table, access the table variable.
You cannot access the field variable directly via the MCLI.
To enter the Screen Mode:
•
If a command is incorrectly entered, MCLI displays a list of all supported MCLI
commands and MIB variables that start with the entered character string. If there is
only one matching command or MIB variable, MCLI displays the corrected command
or MIB variable at the prompt. The following figure illustrates the entry of the
character "e" and lists the available MCLI commands and MIB variables.
Table variables
Scalar variables
In Line Mode enter the following <MIB Variable / OID name> and press
<Enter>.
4-1