Operating The Vs-88Hdcpxl 8X8 Dvi Matrix Switcher; Routing Inputs To Outputs; Disconnecting The Outputs; Storing And Recalling A Setup - Kramer VS-88HDCPxl User Manual

im Vertrieb von
6 Operating the VS-88HDCPxl 8x8 DVI Matrix
Switcher
This section describes how to:
•
•
•
•
•
•
•
6.1

Routing Inputs to Outputs

To route an input to an output:
•
To route one input to all outputs:
•
6.2

Disconnecting the Outputs

To disconnect one output:
•
To disconnect all outputs at once:
•
6.3

Storing and Recalling a Setup

You can use the STO and RCL buttons to store up to 12 setups and then recall
them as illustrated in
IN 1 is used for setup number 1 and OUT 1 is used for setup number 7.
VS-88HDCPxl - Operating the VS-88HDCPxl 8x8 DVI Matrix Switcher
www.camboard.de
CAMBOARD Electronics
Route inputs to outputs (see
Disconnect outputs (see
Store and recall a setup (see
Acquire the EDID (see
Lock and unlock the front panel (see
Reset the Ethernet configuration to default values (see
Control the machine via the Ethernet port (see
Press an OUT key, followed by an IN key to route this input to that output
Press ALL followed by an IN button. The input is routed to all outputs
Press the OUT button of the output to disconnect and press OFF
Press the ALL button and then press OFF. This disconnects all the outputs
Figure
Tel. 07131 911201
Fax 07131 911203
Section 6.1)
Section 6.2)
Section 6.3)
Section 6.4)
Section
6.
6.5)
Section 6.6)
Section 6.7)
ce-info@camboard.de
15