6
Operating the VS-88HDCPxl 8x8 DVI Matrix
Switcher
This section describes how to:
•
Route inputs to outputs (see
•
Disconnect outputs (see
•
Store and recall a setup (see
•
Acquire the EDID (see
•
Lock and unlock the front panel (see
•
Reset the Ethernet configuration to default values (see
•
Control the machine via the Ethernet port (see
6.1
Routing Inputs to Outputs
To route an input to an output:
•
Press an OUT key, followed by an IN key to route this input to that output
To route one input to all outputs:
•
Press ALL followed by an IN button. The input is routed to all outputs
6.2
Disconnecting the Outputs
To disconnect one output:
•
Press the OUT button of the output to disconnect and press OFF
To disconnect all outputs at once:
•
Press the ALL button and then press OFF. This disconnects all the outputs
6.3
Storing and Recalling a Setup
You can use the STO and RCL buttons to store up to 12 setups and then recall
them as illustrated in
IN 1 is used for setup number 1 and OUT 1 is used for setup number 7.
VS-88HDCPxl - Operating the VS-88HDCPxl 8x8 DVI Matrix Switcher
Section
Section
6.2)
Section
Section
6.4)
Figure
5.
6.1)
6.3)
Section
6.5)
Section
Section
6.7)
6.6)
13