6
Operating the VS-44HDCP 4x4 DVI Matrix
Switcher
This section describes how to:
Route inputs to outputs (see
Disconnect outputs (see
Store and recall a setup (see
Lock and unlock the front panel (see
Acquire the EDID (see
Reset the Ethernet configuration to default values (see
6.1
Routing Inputs to Outputs
To route an input to an output:
Press an OUT key, followed by an IN key to route this input to that output
To route one input to all outputs:
Press ALL followed by an IN button. The input is routed to all outputs
6.2
Disconnecting the Outputs
To disconnect one output:
Press the OUT button of the output to disconnect and press OFF
To disconnect all outputs at once:
Press the ALL button and then press OFF. This disconnects all the outputs
10
Section
Section
6.2)
Section
Section
6.5)
VS-44HDCP - Operating the VS-44HDCP 4x4 DVI Matrix Switcher
6.1)
6.3)
Section
6.4)
Section
6.6)