Mitsubishi Electric PUZ-M200YKA Service Manual page 83

<Function setting>
Select "Service" from the Main menu, and press the [
1
Select "Setting" from the Service menu, and press the [
Select "Function setting", and press the [
Set the indoor unit refrigerant addresses and unit numbers with the F1
2
through F4 buttons, and then press the [
setting.
<Checking the indoor unit No.>
When the [ ] button is pressed, the target indoor unit will start fan opera-
tion. If the unit is common or when running all units, all indoor units for the se-
lected refrigerant address will start fan operation.
When data collection from the indoor units is completed, the current settings
3
appears highlighted.
Non-highlighted items indicate that no function settings are made.
Screen appearance varies depending on the "Unit No." setting.
Use the F1 or F2 button to move the cursor to select the mode number,
4
and change the setting number with the F3 or F4 button.
When the settings are completed, press the [
5
data from the remote controller to the indoor units.
When the transmission is successfully completed, the screen will return to the
Function setting screen.
Note: • Make the above settings only on Mr. Slim units as necessary.
• The above function settings are not available for the CITY MULTI units.
• Table 1 summarizes the setting options for each mode number. Refer to
the indoor unit Installation Manual for the detailed information about ini-
tial settings, mode numbers, and setting numbers for the indoor units.
• Be sure to write down the settings for all functions if any of the initial
settings has been changed after the completion of installation work.
OCH737
] button.
] button.
] button.
] button to confirm the current
] button to send the setting
83
Settings menu
Function setting
Service menu:
F1 F2 F3 F4
Function setting
Ref. address
Unit No.
Grp./1/2/3/4/All
Monitor:
Cursor Address
F1 F2 F3 F4
Function setting
Ref. address Grp.
Mode 1
Mode 2
Mode 3
Mode 4
Request:
Cursor Cursor
F1 F2 F3 F4
Function setting
Ref. address Grp.
Mode 1
Mode 2
Mode 3
Mode 4
Request:
Cursor Cursor
F1 F2 F3 F4
Function setting
Ref. address
Sending data
F1 F2 F3 F4