Mitsubishi Electric PUZ-M200YKA Service Manual page 33

10-3-3. Self-diagnosis for wireless remote controller (Type C)
When a malfunction occurs to air conditioner, both indoor unit and outdoor unit will stop and operation lamp blinks to inform
unusual stop.
<
Malfunction-diagnosis method at maintenance service>
CHECK
CHECK
display
TEMP
ON/OFF
ON/OFF
button
AUTO STOP
FAN
MODE VANE AUTO START
CHECK LOUVER
CHECK
TEST RUN
button
SET RESET CLOCK
10-3-4. Self-diagnosis for wireless remote controller (PAR-SL100A-E)
B
3
5
OCH737
[Procedure]
1. Press the CHECK button twice.
Refrigerant
address
• "CHECK" lights, and refrigerant address "00" blinks.
display
• Check that the remote controller's display has stopped before
continuing.
Temperature
2. Press the TEMP
button
• Select the refrigerant address of the indoor unit for the self-diagnosis.
Note: Set refrigerant address using the outdoor unit's DIP switch (SW1).
(For more information, see the outdoor unit installation manual.)
3. Point the remote controller at the sensor on the indoor unit and press
the HOUR button.
HOUR
• If an air conditioner error occurs, the indoor unit's sensor emits an
button
intermittent buzzer sound, the operation light blinks, and the check
h
code is output.
min
(It takes 3 seconds at most for check code to appear.)
4. Point the remote controller at the sensor on the indoor unit and press
the ON/OFF button.
• The check mode is cancelled.
1. Press the
to disable it (
A
2. Press the
3. Press the
of the indoor
4. Press the
f
1
INDICATOR lamp.
5. Press the
check is completed.
2
4
buttons.
button 1 to stop the air conditioner.
is off).
button 2 for 5 seconds.
A
button 5 to select the refrigerant address (M-NET address) B
button 4.
indoor unit and the number of blinks of the OPERATION
button 1.
A and the refrigerant address (M-NET address) B
33
is on), press the button 3