Mitsubishi Electric PUZ-M200YKA Service Manual page 54

Phone Calls From Customers
The room cannot be cooled or heated sufficiently.
Sound 1 A gas escaping sound is heard
comes out
sometimes.
from the air
conditioner.
2 A cracking sound is heard
sometimes.
3 A buzzing sound is heard
sometimes.
4 A ticking sound is heard from
the outdoor unit sometimes.
5 A sound, similar to water
flowing, is heard from the unit.
Something 1 The fan speed does not match
is wrong
the setting of the remote
with the
controller during DRY
blower.....
operation.(No air comes out
sometimes during DRY
operation.)
2 The fan speed does not match
the setting of the remote
controller in HEAT operation.
OCH737
How to Respond
1 Check the set temperature of remote controller.
The outdoor unit cannot be operated if the set
temperature is not appropriate.
The outdoor unit operates in the following modes.
COOL: When the set temperature is lower than
the room temperature.
HEAT: When the set temperature is higher than
the room temperature.
2 Check if filters are not dirty and clogged. If filters
are clogged, the airflow amount will be reduced
and the unit capacity will be lowered. See the
instruction manual that came with the product for
how to clean the filters.
3 Check there is enough space around the air
conditioner.
If there are any obstacles in the air intake or air
outlet of indoor/outdoor units, they block the
airflow direction so that the unit capacity will be
lowered.
1 This is not a malfunction.
This is the sound when the flow of refrigerant in
the air conditioner is switched.
2 This is not a malfunction.
This is the sound when internal parts of units
expand or contract when the temperature
changes.
3 This is not a malfunction.
This is the sound when the outdoor unit starts
operating.
4 This is not a malfunction.
This is the sound when the fan of the outdoor unit
is controlling the airflow amount
in order to keep the optimum operating condition.
5 This is not a malfunction.
This is the sound when the refrigerant is flowing
inside the indoor unit.
1 This is not a malfunction.
During the DRY operation, the blower's ON/OFF is
controlled by the microprocessor to prevent
overcooling and to ensure efficient dehumidification.
The fan speed cannot be set by the remote
controller during DRY operation.
2 This is not a malfunction.
1) When the HEAT operation starts, to prevent the
unit from blowing cold air, the fan speed is
gradually increased from zero to the set speed,
in proportion to the temperature rise of the
discharged air.
2) When the room temperature reaches the set
temperature and the outdoor unit stops,
the unit starts the LOW AIR operation.
3) During the HEAT operation, the DEFROST
operation is performed to defrost the outdoor
unit. During the DEFROST operation, the
blower is stopped to prevent cold air coming
out of the indoor unit.
54
Note
The up/down vane will be
automatically set to
horizontal blow in these
cases listed up on the left
(1–3). After a while, the
up/down vane will be
automatically moved
according to the setting of
the remote controller.