Reset And Restore - D-Link SECURICAM Network DCS-2100+ Manual

Reset and Restore

There is a button hidden in the pinhole beside the Ethernet socket. It is
used to reset the system or restore the factory default settings.
Sometimes resetting the DCS-2100+ will return the system back to a
normal state. If the system still has problems after reset, restore the
factory settings and install again:
RESET: 1. Lightly insert a paper clip (or a similar sized tool) into the
2. The LED on the front of the camera will begin blinking red
3. When the LED stops the blinking fast and starts blinking
once every second, the reset is completed.
RESTORE: 1. Insert the paper clip, or another similar tool, and press
and continuously hold down the button recessed inside
2. Wait for the LED on the front of the camera to blink red
3. Withdraw the tool after the second cycle of the LED
reset hole on the back of the camera, press lightly and
then release the button.
and green fast.
the reset hole.
and green and hold the button through two cycles of
blinking (about 5-7 seconds.)
blinking and a factory restore has been completed.
Restoring the factory defaults will result in the
loss of any previous settings and will require
running the Installation Wizard to find the
camera's IP address.
128
Reset button