D-Link SECURICAM Network DCS-2100+ Manual page 105

Using IP surveillance Software (continued)
Scheduling (continued)
There are three modes in the secondary schedule: Disable, Event mode, and
Continuous mode. If event mode is selected in the secondary schedule, the
camera will record whenever an event is triggered. If continuous mode is
selected, the camera will begin recording continuously after scheduling settings
are saved. These two modes are the same as the primary schedule. Please
refer to the previous section for more detail.
The Schedule Scheme operations
There are six related buttons. "Load...", "Undo", "Clear", "Save", "Save as..."
and "Close" for handling the schedule schemes. These operations are shown
in the figure below.
Load...
This button allows you to load pre-edited schedules from the
scheduling directory for the selected video channel. Note that
you should save the schedule you are currently working on before
loading a new one. Otherwise, the current changes will be lost.
Clear
This button will clear all changes in the current schedule of the
selected video channel.
Save
This button is used for saving changes to the current schedule.
Save As...
This button is used to save the current schedule as another file
name instead of the default name.
Undo
Click on this button to undo all changes for the current schedule
since the last save.
Close
Click on this button to close the scheduler.
105