Reset And Restore - D-Link SECURICAM Network DCS-5300G Manual

Reset and Restore

There is a button hidden in the pinhole on the side of the DCS-5300G. It
is used to reset the system or restore the factory default settings.
Sometimes resetting the DCS-5300G will return the system back to a
normal state. If the system still has problems after reset, restore the
factory settings and install again:
RESET: 1. Lightly insert a paper clip (or a similar sized tool) into the
2. The LED on the front of the camera will begin blinking red
3. When the LED stops the blinking the reset has completed.
RESTORE: 1. Insert the paper clip or other tool, press on the button,
2. Wait for the LED on the front of the camera to blink red
3. Withdraw the tool after the second cycle of the LED
reset hole on the side of the camera, press lightly and
then release the button.
and green.
and hold it down.
and green and hold the button through two cycles of
blinking (about 5-7 seconds.)
blinking and a factory restore has been completed.
Restoring the factory defaults will result in the
loss of any previous settings and will require
running the Installation Wizard to find the
camera's IP address.
131
Reset button