Reset And Restore - D-Link DCS-6220 User Manual

DCS-660 User's Manual

Reset and Restore

There is a button hidden in the pinhole beside the Ethernet socket. It is used to reset the system
or restore the factory default settings. Sometimes resetting the DCS-6620 will return the system
back to a normal state. If the system still has problems after reset, restore the factory settings
and install again:
RESET:
RESTORE:
D-Link Systems, Inc.
Lightly insert a paper clip (or a similar sized tool) into the reset hole on
1.
the back of the camera, press lightly and then release the button.
. The LED on the front of the camera will begin blinking red and green.
3. When the LED stops the blinking the reset has completed.
Insert the paperclip or other tool and press on the button continuously.
1.
.
Wait for the LED on the front of the camera to blink red and green and
hold the button for 10 seconds.
3.
Withdraw the tool after the second cycle of the LED blinking and a factory
restore has been completed.
Restoring the factory defaults will result in the loss
of any previous settings and will require running
the Installation Wizard to return the DCS-6620 to a
normal state.
Reset and Restore
Reset button
130