Use Instructions - Stamina 35-1681A Owner's Manual

USE INSTRUCTIONS

TRAMPOLINE MODE AND INCLINE MODE
Your Circuit Trainer Trampoline can be used in the INCLINED mode or the TRAMPOLINE mode.
When the trampoline bed is horizontal, your Circuit Trainer Trampoline is in the TRAMPOLINE mode.
When the trampoline bed is adjusted at an angle, your Circuit Trainer Trampoline is in the INCLINE
mode for use with a medicine ball. Please see the following steps to switch from the TRAMPOLINE
mode to the INCLINE mode.
STEP 1:
Unplug the sensor wire from back of the METER(20). Remove the METER(20) from the
MOUNTING BRACKET(22). Unscrew the LOCKING KNOB(24) and remove the SENSOR DETECTOR(21)
from the mounting bar.
STEP 2:
Refer to illustration R2. Unscrew the two HOOKED LEGS(8) from the trampoline. Fold the
HOOKED LEGS(8) down and secure in folded position with the elastic Bands. Unfold the LONG HOOKED
LEGS(9) and screw the LONG HOOKED LEGS(9) into the threaded connectors on the rail frame.
R1
STEP 3:
Place the trampoline in the normal use position. Loosen the LOCKING KNOB(24) on the SENSOR
DETECTOR (21). Slide the SENSOR DETECTOR(21) onto the mounting bar and slide up until it touches the
rail frame. Adjust the position of the SENSOR DETECTOR(21) so that the tip is slightly touching the bottom
of the MAT(5). Be sure the SENSOR DETECTOR(21) is not pressed firmly against the bottom of the mat
or bent downward. If it is not adjusted correctly, there is a chance that the SENSOR DETECTOR(21) won't
work properly or that the arm will break during use. Lock the SENSOR DETECTOR(21) in position with the
LOCKING KNOB(24). The Circuit Trainer Trampoline will look as shown in illustration R4 after assembly.
R3
Mounting
Bar
Mounting
Bar
Tip
Elastic Band
11
R2
Elastic Band
Threaded Connector
R4